FAQ
Lenses
How to install your Pinlock lens
- Remove the helmet visor from the helmet.
- Check if the arrows on the Pinlock® pins in the visor are pointing outwards.
- Flex the helmet visor and place the Pinlock® lens between the two pins.
- Check with natural light if the silicon seal on the Pinlock lens makes full contact with the helmet visor.
- Remove the protective film from the Pinlock lens.
- Fit the helmet visor back on the helmet.
For a detailed instruction check the video or download the instruction manual.
How to clean your Pinlock lens
- Remove the helmet visor from the helmet.
- Flex the helmet visor delicately until there is no more tension on the Pinlock lens. Carefully remove the Pinlock lens from its position, avoid touching the lens surface.
- Softly remove all dirt with a dry microfiber cloth. Only clean the Pinlock lens and the helmet visor using lukewarm water and a soft microfiber cloth.
- Allow the Pinlock lens and the helmet visor to dry naturally before reassembling them.
- Flex the helmet visor and place the Pinlock lens between the two pins.
- Check with natural light if the silicon seal on the Pinlock lens makes full contact with the helmet visor.
- Fit the helmet visor back on the helmet.
Pins
Adjust your One Component Pin
- Please remove the Pinlock® lens from the visor before adjusting the Pinlock® One Component Pin.
- Adjust the pins by pushing them outwards and turning them with your fingers before pushing them back in. Use steps of maximum 45° degree tension build up.
- When the silicone seal of the Pinlock lens makes a full seal all around the lens and the visor, the adjustment is complete.
Does your lens not make a full seal with your pins at maximum tension? Feel free to contact us at info@pinlock.com.
Adjust your Two Component Pin
- Please remove the Pinlock® lens before adjusting the Pinlock® Two Component Pin.
- You can adjust the position of the pin with a flathead screwdriver or bank card. Use steps of maximum 45° degree tension build up.
- When the silicone seal of the Pinlock lens makes a full seal all around the lens and the visor, the adjustment is complete.
Does your lens not make a full seal with your pins at maximum tension? Feel free to contact us at info@pinlock.com.
Adjust your Three Component Pin
- Please remove the Pinlock® lens before adjusting the Pinlock® Three Component Pin.
- Adjust the tension of the Pinlock lens by turning the hexagon on the inside of the visor using a 5 mm hexagon tool. Use steps of maximum 45° degree tension build up.
- When the silicone seal of the Pinlock lens makes a full seal all around the lens and the visor, the adjustment is complete.
Does your lens not make a full seal with your pins at maximum tension? Feel free to contact us at info@pinlock.com.
Adjust your Tear-off Pin
- Please remove the Pinlock® lens before adjusting the Pinlock® Tear-off Pin.
- Adjust the tension of the Pinlock lens by turning the hexagon on the inside of the visor using a 5 mm hexagon tool. Use steps of maximum 45° degree tension build up.
- When the silicone bead of the Pinlock lens makes a full seal all around the lens and the visor, the adjustment is complete.
Does your lens not make a full seal with your pins at maximum tension? Feel free to contact us at info@pinlock.com.